Antennas with coaxial connectors

Carrier Class Antennas, MiMo Sectors, and other RF elements antennas.

24 topics in this forum

  1. Carrier class vs TwistPort testing

    • 8 replies
    • 1,557 views
    • 4 replies
    • 1,692 views
    • 2 replies
    • 3,162 views
  2. 2x2 vrs 3x3 5Ghz Sectors

    • 3 replies
    • 1,566 views
  3. Beam forming Antennas

    • 9 replies
    • 1,507 views
  4. Camo Paint

    • 2 replies
    • 436 views
    • 5 replies
    • 1,033 views
    • 1 reply
    • 197 views
    • 0 replies
    • 278 views
  5. Dual Band - 2.4 / 5.8 antenna

    • 2 replies
    • 272 views
  6. Dual Polarity

    • 2 replies
    • 484 views
    • 6 replies
    • 1,527 views
    • 3 replies
    • 935 views
    • 3 replies
    • 288 views
  7. ID Product by serial

    • 3 replies
    • 1,185 views
    • 1 reply
    • 1,540 views
  8. Request: 1+1 Adapter

    • 1 reply
    • 636 views
    • 7 replies
    • 655 views
  9. Sector CarrierClass 2-14`

    • 1 reply
    • 632 views
    • 5 replies
    • 913 views
    • 0 replies
    • 190 views
    • 0 replies
    • 318 views
    • 2 replies
    • 252 views
  10. Wind Load for SEC-CC-5-20

    • 1 reply
    • 197 views
  • Latest Facebook posts

    No posts were found.

  • Posts

    • Hi Francesco, to your questions: - the drain hole is there to protect the inside from condensed water. By sealing it with silicon properly, it will be IP66 rated - the hole is small enough. - yes the red plugs provide IP66 rating - more on this in the private message just sent Best regards
    • Dear, I have some question about your StationBox ALU enclosures. - For IP66 rating you write, in your web site, that it need to sealing the drain hole. It is sufficient to seal this hole with silicon? Why you made this hole in the enclosure if to achieve IP66 rating we need to filled it? - For IP66 rating we can employ your  red rubbery covers/plugs that filled the N-cutout holes in a front panel of enclosure? We will use only some of these holes for N connector. If the answer at this question is not, can you suggest some items to fill the cutout for N connector to maintain the IP66 rating? - We need to use two holes for cable gland (one for RJ45 waterproof Ethernet connector and another for DC power supply). It is possible to order StationBox Alu with one rounded hole with specific diameter  in place of one for N cutout?  Many thanks for your support. Best Regards   Francesco 
    • The azimuth is not 'calculated' either, the calculator merely shows you the 'heading' of the antenna in the Multi CPE setup. The direction of the 'heading' is manual, and it is the clockwise angle from the North.
    • The old one will have 'TPA-PAF-04_redu_1_v3' and the new one 'TPA-PAF-04_redu_1_v4' printed directly on the part.